Type DL Notching Tool
A leg guided tool for cutting rectangular pieces up to 2¼" x 2 1/8" deep in one operation from the corners of sheet metal panels prior to bending. It can also, by a series of cuts, be used for producing notches larger than its own size. The die size is made to fit direct into the type 2 frame (supported by ring H) and the top tool is bored to suit punch holder K. Special notch tools can be made to suit customer requirements.

Radius Cropping Tools

For cropping off to length and at the same time radiusing both sides of the cut of light mild steel bars and strip up
to 3mm thick. Four standard tools are available with adjustable side gauges to accommodate intermediate widths. The punch has a 1" dia. shank and the bottom die fits direct into the type 2 frame.

Non -Standard tools can also be supplied.

RC1 Special Offer Price: £350.00 (was £439.00)

RC2 Special Offer Price: £325.00 (was £439.00)

RC4 SPecial Offer Price: £350.00 (was £439.00)

All offer prices subject to P&C and VAT

Louvre Tools

• These tools pierce and form louvres in one operation
• Available in four standard lengths
• The standard gap/opening of ¼" is the same for all four tools
• Lower die is held by screws to the top face of the type 2 bolster frame
• Louvre tools up to 4" can be drilled to suit the type 1 bolster frame
• Standard shank 1" dia

Twin Radius tools
These tools are designed to radius the corners of sheet panels with each tool giving two alternative radii and one straight cutting edge. Three leg guides on the punch ensure accurate alignment in the die. Four separate tools can be supplied from stock to produce the following radii:

• The standard dies fit in the type 2 frame supported by ring H
• Standard top tools have 1" dia shanks
• Special twin or single radius tools can be made to order

TR1: 1" & 7/8"
TR2: ¾" & 5/8"
TR3: ½" & 3/8"
TR4: ¼" & 1/8"